Connections Setup; Lan; Ipv4 - D-Link DAP-1325 User Manual

DAP-1325 N300 Wi-Fi Range Extender
User Manual

Connections Setup

In this menu you can configure basic parameters of the extender for operation in the local network.

LAN

To configure the extender's basic parameters, go to the Connections Setup / LAN page.

IPv4

Go to the IPv4 tab to change IPv4 address and configure the built-in DHCP server.
Figure 38. Configuring local IP addresses. The IPv4 tab. The IP section.
If needed, edit the basic settings.
Parameter
IP address
Subnet mask
Gateway IP address
Device domain name
When needed settings are configured, click the APPLY button.
IP
The IP address of the extender in the local subnet. By default, the
following value is specified: 192.168.0.50.
The mask of the local subnet. By default, the following value is
specified: 255.255.255.0.
The gateway IP address which is used by the extender to connect to
the Internet (e.g., for synchronizing the system time with an NTP
server). Optional.
The name of the device attached to its IP address in the local subnet.
Page 44 of 92
Configuring via Web-based Interface
Description