Package Contents DAP-1325 Mesh Wi-Fi Range Extender Wi-Fi Configuration Card Quick Install Guide If any of the above items are missing, please contact your reseller. Before You Begin • For setup, you will want your Range Extender to be plugged into an available outlet as close to your Wi-Fi Router as possible.
Green The WPS button has been pushed and the device is Blinking establishing a connection. Signal Strength Indicator Very Weak (1 x Amber) Weak (1 x Green) Good (2 x Green) Strong (3 x Green) DAP-1325 Install Guide...
Page 4
Setup, on page 6. Once confirmed that the WPS light is blinking on your router, within one minute, press the WPS button on your Range Extender for 2-3 seconds. The Status LED should start to blink green. DAP-1325 Install Guide...
Page 5
Range Extender LED does not turn solid green within 3 minutes, move your Range Extender to a wall outlet closer to your wireless router. Signal Strength Indicator Very Weak (1 x Amber) Weak (1 x Green) Good (2 x Green) Strong (3 x Green) DAP-1325 Install Guide...
Page 6
Once connected to your Range Extender, launch the QRS Mobile app, wait for the Introduction Screen Up to 30 to change to the Welcome Screen seconds (this may take up to 30 seconds), then tap Start to continue. DAP-1325 Install Guide...
Page 7
Range Extender LED does not turn solid green within 3 minutes, move your Range Extender to a wall outlet closer to your wireless router. Signal Strength Indicator Very Weak (1 x Amber) Weak (1 x Green) Good (2 x Green) Strong (3 x Green) DAP-1325 Install Guide...
Note: If you have changed the Wi-Fi Network name or Wi-Fi Password, the device you are currently using to connect to your Range Extender will drop. You will need to go to your Wi-Fi Settings and connect to your Range Extender using the new network name and password. DAP-1325 Install Guide...
Page 9
Wi-Fi signal is still strong. Use the Smart Signal Indicator to help find a location with a strong signal. The more bars lit on the signal indicator, the stronger the Wi-Fi signal is. DAP-1325 Install Guide...
Page 10
Mesh Smart Roaming Requirements: 1. The Wi-Fi device (e.g. SmartPhone, Tablet) must support the 802.11k/v standard. 2. The Wireless Name (SSID) & Wireless Password must be the same on both the Mesh Wi-Fi Range Extender and your Wireless Router. DAP-1325 Install Guide...
Where such specific license terms entitle you to the source code of such software, D-Link will provide upon written request via email and/or traditional paper mail the applicable GPL and LGPLsource code files via CD-ROM for a nominal cost to cover shipping and media charges as allowed under the GPL and LGPL.