Sony PXW-Z190 Operating Instructions Manual page 120

About charging the battery pack
• Use the Charger (supplied) to charge the
designated batteries only. If you charge other
types of batteries, those batteries may leak, heat
up, burst, or give an electric shock, resulting in
burns or injury.
• Remove the charged battery from the Charger.
• The charge lamp of the supplied Charger
flashes in 2 patterns as follows:
Fast-flashing...Turns on and off rapidly at about
0.15-second intervals.
Slow-flashing...Turns on and off alternately for
about 1.5 seconds, and turns off completely for
about 1.5 seconds. The lamp repeats this
sequence.
• If the charge lamp is fast-flashing, remove the
battery that is being charged, and then reattach
the same battery again firmly. If the charge
lamp continues fast-flashing, the cause could be
that the battery is damaged, or the battery is not
a designated type. Check the battery to confirm
whether it is a designated type or not. If it is a
designated type, remove the battery first, and
then attach a brand-new battery or another
known-to-be-good battery to see if the Charger
is working correctly. If the Charger is working
correctly, the cause could be that the battery is
damaged.
• If the charge lamp is slow-flashing, the Charger
is in standby mode and charging is suspended.
When the ambient temperature is out of the
appropriate temperature range for charging, the
Charger suspends charging automatically and
enters standby mode. When the ambient
temperature returns to an appropriate
temperature, the Charger restarts charging and
the charge lamp lights up. We recommend
charging the battery pack in an ambient
temperature of from 10 °C to 30 °C (50 °F to
86 °F).
About handling of your camcorder
On use and care
• Do not use or store the camcorder and
accessories in the following locations.
Anywhere extremely hot or cold.
Never leave them exposed to temperatures
above 60 °C (140 °F), such as under direct
sunlight, near heaters or in a car parked in the
sun. They may malfunction or become
deformed.
Near strong magnetic fields or mechanical
vibration.
The camcorder may malfunction.
Near strong radio waves or radiation.
The camcorder may not be able to record
properly.
Near AM receivers and video equipment.
Noise may occur.
On a sandy beach or anywhere dusty.
If sand or dust gets in your camcorder, it may
malfunction. Sometimes this malfunction
cannot be repaired.
Near windows or outdoors, where the LCD
screen, the viewfinder, or the lens may be
exposed to direct sunlight.
This damages the inside of the viewfinder or
the LCD screen.
Anywhere very humid.
• For DC or AC operation, use the accessories
recommended in these operating instructions.
• Do not let your camcorder get wet, for example,
from rain or sea water. If your camcorder gets
wet, it may malfunction. Sometimes this
malfunction cannot be repaired.
• If any solid object or liquid gets inside the
casing, unplug your camcorder and have it
checked by a Sony dealer before operating it
any further.
• Avoid rough handling, disassembling,
modifying, physical shock, or impact such as
hammering, dropping or stepping on the
product. Be particularly careful of the lens.
• Do not use a deformed or damaged battery pack.
• Keep the ON/STANDBY switch setting to
STANDBY when you are not using your
camcorder.
• Do not wrap your camcorder with a towel, for
example, and operate it. Doing so might cause
heat to build up inside.
• When disconnecting the power cord (mains
lead), pull it by the plug and not the lead.
• Do not damage the power cord (mains lead)
such as by placing anything heavy on it.
• Keep metal contacts clean.
• Keep the Wireless Remote Commander and
button-type battery out of children's reach. If
the battery is accidentally swallowed, consult a
doctor immediately.
• If the battery electrolytic liquid has leaked,
consult your local authorized Sony service
facility.
120