Installing Display Panel - Dell P101F Service Manual

Steps
1. Remove the six (M2.5x2.5) and two (M2x2) screws that secure the display panel to the display back cover and place to
display forward to access the EDP cable at the back.
NOTE: Do not pull and release the Stretch (SR) Tapes from the display panel. There is no need to separate the brackets
from the display panel.
2. Peel off the adhesive tape from over the EDP connector and lift the latch.
3. Disconnect the EDP cable connector from the display panel and lift it away from the display back cover.

Installing display panel

About this task
Steps
1. Connect the EDP cable to the connector on the back of the display panel.
Disassembly and reassembly 75