Power button
Removing the Power Button
Prerequisites
1. Follow the procedure in
2. Remove the
SD
Card.
3. Remove the
base
cover.
4. Disconnect the battery.
5. Remove the
IO
board.
6. Remove the
solid state
About this task
The figure indicates the location of the Power Button and provides a visual representation of the removal procedure.
Steps
1. Disconnect the system board cable from the connector on the power button daughterboard.
2. Remove the two (M2x3) screws that secure the shield over the power button module and peel back the adhesive tape from
over the power button daughterboard.
3. Lift the Power Button module away from the computer.
Installing the Power Button
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the power button and provides a visual representation of the installation procedure.
before working inside your
drive.
computer.
Disassembly and reassembly
63