Display Assembly; Removing The Display Assembly - Dell P101F Service Manual

Steps
1. Place the Power Button module onto the mounting points on the palmrest.
2. Place the shield on top of the power button module and install the two (M2x3) screws to secure the shield onto the power
button. Place the power button daughterboard on the palmrest..
3. Connect the cable connector from the system board to the connector on the power button daughterboard.
Next steps
1. Install the WWAN card.
2. Install the Solid state
3. Install the IO board.
4. Install the battery.
5. Install the base cover.
6. Install the SD Card.
7. Follow the procedure in

Display assembly

Removing the Display Assembly

Prerequisites
1. Follow the procedure in
2. Remove the SD Card.
3. Remove the base cover.
4. Disconnect the battery.
About this task
The figure indicates the location of the LCD Assembly and provides a visual representation of the removal procedure.
64 Disassembly and reassembly
drive.
After working inside your
before working inside your
computer.
computer.