Hardware Description And Installation; Led Indicators - D-Link DSL-2544N User Manual

Section 2 – Installation

LED Indicators

Note: The figures in this document are for reference only.
The following table describes the LEDs of the device.
LED Color
Green
Power
Red
DSL Green
Green
Internet
Red
LAN 1/2/3/4 Green
2.4GHz/5GHz Green
USB Green
WPS Green
D-Link DSL-2544N User Manual

Hardware Description and Installation

Status
On The initialization of the system is complete.
On The device is powered on.
Blinking The firmware is upgrading.
Off No signal is being detected.
Blinking The device is handshaking with the physical layer of the office end.
On A connection is set up with the physical layer of the office end.
Off The device is under the Bridge mode or powered off.
On A successful connection has been made.
The authentication of the PPP dial-up has failed or MER has failed to obtain the correct IP
On
address.
Off The Ethernet interface is not properly connected.
Blinking The Ethernet interface is properly connected and data is being transmitted.
On The Ethernet interface is properly connected, but no data is being transmitted.
Blinking The WLAN function is enabled and data is being transmitted on the WLAN.
On The WLAN function is enabled, but no data is being transmitted on the WLAN.
Off The WLAN function is disabled.
On The USB connection is set up or USB flash disk is enabled.
Blinking A connection is set up and data is being transmitted.
Off No signal is detected.
Connection is successfully established between the router and the client, the LED would light
Solid light
steady for 5 seconds.
Figure 1 Front panel
Description
10