D-Link DSL-224 User Manual page 12

Section 2 – Installation
LED Color
DSL Green
Green
Internet
Red
The following table describes the interfaces of the device.
Interface/Button
DSL
LAN4/3/2/1
WPS
WIRELESS ON/OFF
ON/OFF
12V DC IN (power)
Reset (On the bottom side)
D-Link DSL-224 User Manual
Status
Off No signal is being detected.
Blinking The device is handshaking with the physical layer of the office end.
On A connection is set up with the physical layer of the office end.
Off The device is under the Bridge mode or powered off.
Blinking Internet data is being transmitted in the routing mode.
On The IP is connected.
On The device is attempted to become IP connected, but failed.
RJ-11 interface for connecting the host to the telephone jack on the wall or the MODEM interface of the
splitter through a telephone line.
For a PC or other Ethernet-abled device to join the LAN of 224 by being connected to this interface with
RJ-45 cable.
Press the button to enable or disable WPS function.
Press the button to enable or disable WLAN function.
Power switch, which is used to power on or power off the device.
Interface for connecting the power adapter.
Press and hold the button for 15~20 seconds to restore the factory defaults.
Description
Figure 2 Rear panel
Description
10