D-Link DSL-224 User Manual page 44

Section 3 – Web Configuration
Reset Click it to refresh this page.
Set direction of the data packets to WAN, the page shown in the right figure
appears.
The following table describes the parameters and buttons of this page:
Field
Direction Select
WAN Setting
WAN Interface
Services Allowed
Add
Reset
Access Control List IPv6
Choose ADVANCED > Access Control List > Access Control List IPv6. In this
page, you can permit the data packets from LAN or WAN to access the router in
IPv6 protocol. You can configure the IP address for Access Control List (ACL). If
ACL is enabled, only the effective IP address in the ACL can access the router.
For the parameters description in this page, you can refer to the description of
Access Control List.
Description
Select the router interface. You can select LAN or
WAN. In this example, WAN is selected.
You can choose Interface or IP Address.
Choose the interface that permits data packets from
WAN to access the router.
You can choose the following services from WAN:
Web, Telnet, SSH, FTP, TFTP, SNMP or PING.
After setting the parameters, click it to add an entry
to the Current ACL Table.
Click it to refresh this page.
42