Table of Contents
Advertisement
Note - It is highly recommended to have this equipment commissioned by a Flowtech approved engineer.
Any damage or loss incurred through incorrect commissioning by an unapproved engineer will not be
covered by the warranty.
If you wish for Flowtech to arrange this please contact us.
Please see the warranty section for details.
Remember to fill in details for future use for re-commission unit.
Remember – When installing a expansion vessel with the pressurisation unit make sure the cold pressure is
the same in order for the system to work effectively.
Flowpress WMDA 1-1 and Flowpress WMDA 1-2 - Under no circumstances must be used to fill a
system of any size.
flowpress
WMDA Pressurisation Units
7
Advertisement
Table of Contents
Need help?
Do you have a question about the flowpress WMDA and is the answer not in the manual?