Table of Contents
Advertisement
10
Mains Water
Requirement
Pressure
Below 1 Bar
No Restrictor. Install Filter Only
1 – 4 Bar
Low Pressure Restrictor (coloured)
Above 4 Bar
High Pressure Restrictor (white)
If no restrictor is required, the filter must be removed from one of the restrictors and installed on its own. The
following diagram shows how to remove the filter:
To install the flow restrictor/filter, hold it by the tab and push it into the opening of the float valve connection,
as shown in the diagram below:
Advertisement
Table of Contents
Need help?
Do you have a question about the flowpress WMDA and is the answer not in the manual?