Technical Information; Intended Use; Improper Use; Marking - FLOWTECH flowboost F.V Operation And Maintenance Manual

Technical Information

Vertical multi-stage pumps with suction and delivery connections of the same diameter and arranged along
the same axis (in-line).
Corrosion-resistant bearing sleeves lubricated by the pumped liquid.
A pump with thrust bearing and sleeve coupling for use of any standard motor with IM V1 construction.

Intended use

For clean liquids: non-explosive and non-flammable, non-hazardous for health or the environment, non-
aggressive for pump materials, not containing abrasives, solid or fibrous particles. With seal rings in EPDM the
pump is not suitable for use with oil.
Liquid temperature:
- From -15 °C to +90 °C.

Improper use

The device is designed and built only for the purpose described. Improper use of the device is forbidden,
as is use under conditions other than those indicated in these instructions. Improper use of the product
reduces the safety and the efficiency of the device, Flowtech shall not be responsible for failure or accident
due to improper use. Do not use in ponds, tanks or swimming pools or where people may enter or come into
contact with the water.

Marking

The following picture is a copy of the name-plate that is on the external case of the pump

Technical data

Dimensions and weight (see technical catalogue).
Nominal speed 2900/3450 rpm
Protection IP54
Supply voltage / Frequency
up to 240V 1~ 50/60 Hz
up to 480V 3~ 50/60 Hz
Check that the mains frequency and voltage correspond to the electrical characteristics shown on the
indicator plate. The electric data marked on the label are referred to the nominal power of the motor.
flowboost
F.V Pump Manual
7