Safety Warnings & Precautions - FLOWTECH flowboost F.V Operation And Maintenance Manual

Safety Warnings &
Precautions
These instructions should be read and clearly understood before working on the system. Please
read this manual carefully and all of the warning signs attached before installing or operating the
equipment keep this manual handy for your reference. This equipment should be installed, adjusted
and serviced by trained and qualified personnel. Failure to observe this precaution could result in
bodily injury.
WARNING!
HAND-PAP
shafts can be hazardous.
WARNING!
HAND-PAP
fixed to earth.
WARNING!
HAND-PAP
Do not check signals during operation. When the power is turned on and the running
command is on, the motor will start rotating. The stop key is only effective when the
function is set. If there is a power failure and an operation instruction is given the unit
may start automatically when the power is reinstated.
WARNING!
HAND-PAP
a room that is not exposed to direct sunlight and is well ventilated.
Avoid environments which have a high ambient temperature, high humidity or
excessive condensation. Avoid dust. Corrosive gas, explosive gas, inflammable gas,
grinding-fluid mist and salt damage, etc.
WARNING!
HAND-PAP
connectors.
WARNING!
HAND-PAP
hazardous line voltages. When servicing drives and electronic controllers, you may be
exposed to components at or above the line potential. Extreme care should he taken
to protect against shock. Dangerous voltage may exist after the power light is off.
Wait more than 5 minutes after turning off the power supply before performing
maintenance or inspection. Hazard of electric shock. Disconnect incoming power
before working on this unit.
WARNING!
HAND-PAP
Observe the regional regulations for electrical installation!
flowboost
- Install an emergency stop key separately from the isolator. Rotating
- This equipment has a high leakage current and must be permanently
- Do not attach or remove wiring or connectors when the power is applied.
- Make sure that the input voltage is correct. Be sure to install the unit in
- Do not connect the power source to any terminals except power
- Motor control equipment and electronic controllers are connected to
- The inverter should be protected separately against ground fault.
F.V Pump Manual
5