Table of Contents
Advertisement
ACCESSORY
1. Attach the auxiliary solution hose to the output nipple A.
2. Disconnect hose at vac shoe using and connect vac hose using
coupler (22071) that is included with Voyager machine.
3. Turn the solution control valve B to
4. Press the Pump switch "ON".
5. Lower the vac lever to the "ON" position to start the vac motor.
6. Make sure the solution control valve is returned to the
7.
position before using the Voyager for self-contained
carpet cleaning.
CLEANUP AND STORAGE
Empty the Recovery Tank directly into the floor drain. After each use, rinse tank (including the float-off) with fresh
water. Periodically inspect the recovery tank and decontaminate if necessary, using a Hospital Guide Virucide or
a 1-10 bleach to water solution. This will dissipate the exposure to blood born or infectious contamination. Waste
water shoud be disposed of properly. Clean the inside of the recovery dome also.
Empty the Solution Tank by detaching the sight hose and empty directly into the floor drain.
Flush the Solution System with 1 gallon of CLEAN water.
!
CAUTION:
PERIODIC MAINTENANCE
EVERY TWO WEEKS:
Clean the solution system by diluting 2 gallons of clean water with a quart of white vinegar (acetic acid) in the
solution tank. Run the solution through the system to remove chemical buildups which could eventually cause it to
plug up.
EVERY 500 HOURS:
Oil the front drive wheel bearings by removing the phillips screw "A" and by
loosening the (2) set screws "B" located on the outside of wheel assembly. Slide
the wheel off the axle and apply 6 drops of 10W oil to bearings. Be careful not to
lose the key in shaft.
INSPECTION
!
WARNING:
To expose working parts for inspection, lay dome back on handle, grasp tank at solution opening and tilt the tank
forward until "NOSE" of tank rests on floor.
ACCESSORY TOOLS & MAINTENANCE
Never allow recovered solution to remain in tank when not in use; nor allow
usused solution to remain in the solution tank when in storage. Inspect and
clean the filter located at the pump port. Remove and rinse with hot water.
Remove the batteries (using the battery cart if available) before making any
adjustments or repiars to the Voyager2.
VGR2 98448 7/1/97
A
B
B
A
9
Advertisement
Table of Contents
