Related Manuals for Windsor CLP
Summary of Contents for Windsor CLP
-
Page 1: Table Of Contents
4. Operating the Extractor 5. Operations & Maintenance 6. Service 7. Wiring Diagrams 8. Vat and Pump Assembly IO. Brush Housing & Drive Assembly 11. Handle w/ Controls Assembly 14. Tank Assembly ..Warranty MODELS: CLP CLP-J CLP/CLP-J 98032 2/1/99... - Page 2 IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precaution must always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE. This machine is for commercial use. Do not operate without filters (dry or wet) in place. Use only as described in this manual.
-
Page 3: Grounding Instructions
INSPECTION Carefully unpack and inspect your extractor for shipping dam- A WARNING: I mproper connection of the equipment- age. Each unit is operated and thoroughly inspected before ship- grounding conductor can result in a risk of electric shock. ping, and any damage is the responsibility of the carrier, who Check with a qualified electrician or service person if you are should be notified immediately. - Page 4 NOTE: Vacuum the carpet and make sure it is cleared of surface debris before cleaning with the CLIPPER. NOTE: Attach strain relief/cord retainer to the power cord. Make a loop in power cord approximately 12” from twist lock receptacle end. Slide cord loop through slot in retainer arm.
- Page 5 OPERATING THE CLIPPER WITH ACCESSORY TOOLS SWITCH CONTROL PANEL Remove screws holding rear ABS panel. The CLIPPER is easily adapted for use with the following Windsor accessory tools: DHT-UPII3-SW-SFW-SW/PRO or replace switches as required. Turn solution valve to “Accessory Tool” position.
-
Page 6: Periodic Maintenance
BRUSH DRIVE MOTOR VAC MOTOR (cont.) Remove exhaust hose from vac motor. To inspect motor brushes, remove brush holder assembly. Disconnect motor lead wires. Brushes should be replaced when worn to 3/8 inch or after Move brush adjustment lever to lowest position and tilt machine about 750 operating hours. - Page 8 VAC & PUMP ASSEMBLY 98032 7/l 8198...
- Page 9 CL P 98032 7/l 6/98...
-
Page 10: Io. Brush Housing & Drive Assembly
BRUSH HOUSING & DRIVE ASSEMBLY... - Page 11 BRUSH HOUSING & DRlvE ASSEMBLY Parts List...
- Page 12 HANDLE CONTROLS ASSEMBLY 98032 7/1/97...
-
Page 13: Handle W/ Controls Assembly
HANDLE w/ CONTROLS ASSEMBLY Parts List 98032 10/21/98... -
Page 14: Tank Assembly
TANK ASSEMBLY CL P 98032 1/14/98... - Page 15 10A 5 0 6 2 3 Label, Chassis Wiring 115V 1OB 5 0 6 7 6 Label, Chassis Wiring 230V 57105 Nut, l/4-20 w/Star Washer Open Open Tank, CLP Solution 75247 442941 Open Open Open 73864 Strainer, 3/8 NPT x 60 Mesh...
-
Page 16: Limited Warranty
If proof of purchase cannot be identified, the warranty start date is 90 days after date of sale to an authorized Windsor distributor. Parts replaced or repaired under warranty are guaranteed for the remainder of the original warranty period.
Need help?
Do you have a question about the CLP and is the answer not in the manual?
Questions and answers