Vitek VTD-TND4RFA4 Quick Start Manual page 4

3. Route the cables and 3. Route the cables and
3. Route the cables and
connect the power & video connect the power & video
connect the power & video
cables, use the rubber plug cables, use the rubber plug
cables, use the rubber plug
to fill the gap of the mounting to fill the gap of the mounting
to fill the gap of the mounting
base, then secure the base, then secure the
base, then secure the
mounting base to the ceiling mounting base to the ceiling
mounting base to the ceiling
or wall with screws. or wall with screws.
or wall with screws.
4. Before adjusting the three-axis camera mount, preview the 4. Before adjusting the three-axis camera mount, preview the
4. Before adjusting the three-axis camera mount, preview the
camera on a monitor, then adjust as necessary achieve the camera on a monitor, then adjust as necessary achieve the
camera on a monitor, then adjust as necessary achieve the
optimum viewing angle. optimum viewing angle.
optimum viewing angle.
Pan 0°~355° Pan 0°~355°
Rotation 0°~355°
Rotation 0°~355° Rotation 0°~355°
5. Install the lower dome on the camera with the included screws,
5. Install the lower dome on the camera with the included screws, 5. Install the lower dome on the camera with the included screws,
then put the trim ring back on the lower dome and rotate clockwise
then put the trim ring back on the lower dome and rotate clockwise then put the trim ring back on the lower dome and rotate clockwise
until it locks.
until it locks. until it locks.
Pan 0°~355°
Tilt 0°~67 °
Tilt 0°~67 ° Tilt 0°~67 °
4