Download Print this page

Panasonic ES-LA90 Operating Instructions Manual page 8

Advertisement

1 Follow the steps outlined below if the status lamp blinks or glows
during the "Clean/Dry/Charge" course or the "Clean/Dry" course.
Blinks
Correctly set the
detergent cartridge and
then restart a course.
If the status lamp goes
out
Continue a course.
When an abnormality has
been corrected
Press and hold [SELECT] for
approximately  seconds to
turn off the status lamp and
then restart a course.
When the status lamp
goes out
Continue a course.

Glows
Remove the shaver from the self‑
cleaning recharger and then
check that the [CLEAN] lamp has
gone out. (Be careful as the blade
may be hot or wet.) Check that
the water tank is correctly
attached, the water tank cap is
securely closed and the self‑
cleaning recharger is placed
horizontally.
When no abnormality was
found
It is time to replace the
detergent cartridge and
cleaning liquid inside the water
tank.
Drain the old cleaning liquid
inside the water tank and then
refill it with water. Replace the
old detergent cartridge and
then restart the course.
When the status lamp glows
again
Contact an authorized service
center.
Cleaning the shaver without the self-cleaning
recharger
We recommend that you clean your
shaver with the self‑cleaning recharger
or the turbo mode for "sonic" vibration
cleaning when the faucet symbol
appears on the LCD panel.
1. Disconnect the power cord from
. Apply some hand soap and some
3. Rotate the lock ring to unlock the
4. Press the 0/1 switch for more than
7
5. Remove the system outer foil and
6. Wipe off any drops of water with a
7. Remove the system outer foil to
. Lubricate the shaver.
the shaver.
water to the outer foil.
0/1 switch.
 seconds to activate the turbo
mode for "sonic" vibration cleaning.
appears on the LCD panel.
After about 0 seconds, it will be
automatically turned off, or you
can turn it off by pressing the 0/1
switch.
press the 0/1 switch for more than
 seconds to activate the turbo
mode for "sonic" vibration cleaning
and clean it with running water.
dry cloth.
allow it to dry completely.
The mark on the left
is for a washable
shaver and indicates
it can be cleaned
with water.

Advertisement

loading