Advertisement
Charging with the self-cleaning
recharger
Thoroughly wipe off any drops of water on or around the recharger
so that it is dry before charging it.
3
2
1
1
Attach the detergent cartridge and the water
tank to the self-cleaning recharger.
Page 6
2
2
Insert the appliance plug.
3
3
Plug in the adaptor.
4
4
Remove the protective cap and then attach the
shaver.
•
Turn the shaver off before attaching.
•
Check that the outer foil is not deformed or damaged when you
are attaching the shaver.
•
The indicators on the LCD panel glow and charging starts.
•
Charging is completed when the indicators on the LCD panel
blink.
(Max. 1 hour later)
4
•
You can keep the shaver attached to the recharger, or
connected to the adaptor, when not using it to maintain full
battery capacity. You cannot overcharge the shaver.
1
Charging without the self-cleaning recharger
You can also charge without the recharger.
1. Insert the appliance plug into the shaver.
. Plug in the adaptor into a household outlet.
1
Cord shaving
If you insert the appliance plug to the shaver and plug in the
adaptor into a household outlet, you can use it even if the battery
capacity is low.
•
If the shaver does not work, continue charging it for approx. 1
minute.
1
Using the lock ring
Use the lock ring to lock or unlock the 0/1 switch.
1. Rotate the lock ring until it clicks.
Unlock the 0/1 switch:
For when shaving, washing the shaver, lubricating the
shaver, or deleting
Lock the 0/1 switch:
For when carrying the shaver.
on the LCD panel.
Advertisement
