Kubota ZD221-48 Workshop Manual page 161

ZD221, WSM
TRANSAXLE
Disconnecting Wiring Harness, PTO Cable and HST Speed
Control Rod
1. Disconnect the connectors from the switches.
2. Remove the wiring harness (1) from the transmission case.
3. Remove the speed control rods (2).
4. Disconnect the PTO cable (3).
(1) Wiring Harness
(3) PTO Cable
(2) Speed Control Rod
W1020254
Disconnecting Parking Brake Rods and Mower Lift Cylinder
Hose
1. Lift the machine and apply the rigid jacks under the main frame.
2. Remove the rear wheels (1).
3. Remove the brake rod pins and the brake rods (3) (4).
4. Disconnect the mower lift cylinder hose (5).
(When reassembling)
Tightening torque
Rear wheel mounting
screw
65 to 75 N'm
6.6 to 7.7 kgf·m
48 to 551bf-ft
• NOTE
• After assembling the parking brake rods, be sure check the
parking brake spring length and play. If the measurement is
not within the factory specifications, adjust the spring
length and play.
(1) Rear Wheel
(5) Mower Lift Cylinder Hose
(2) engine Frame (6) Cooling Fan
(3) Brake Rod (LH) (7) Universal Joint Mounting Bolt
(4) Brake Rod (RH)
W1020512
Separating Transaxle Assembly
1. Remove the transaxle mounting screws.
2. Separate the transaxle from the machine.
(When reassembling)
Tightening torque
Transaxle mounting screw
(M12)
78 to 90 N'm
7.9 to 9.2 kgf·m
58 to 66 Ibf·ft
Transaxle mounting screw
(M10)
48 to 55 N'm
4.9 to 5.7 kgf·m
36 to 41 Ibf-ft
W1020761
2-S15