Download Print this page

Prestige APS-45C Owner's Manual

4 button remote keyless entry system with two auxiliary outputs

Advertisement

Quick Links

Model APS-45C
Owner's Manual
4 Button Remote Keyless Entry System
With Two Auxiliary Outputs
FEATURES:
 2 Four Button, RF Transmitters
 Four Channel Code Learning Receiver
 Remote Panic In All Modes
 Built-In Parking Light Relay
 LED Status Indicator
 Ignition Door Locking/Unlocking
 Horn Output
OPTIONS
:
 Remote Trunk Release
 Remote Power Window Control
 Remote Garage Door Interface
 Remote Engine Starter
 Starter Interrupt
 Siren
 Access Guard / 2 Step Unlock
 Illuminated Entry
Page 1
128-9197
1 of 8

Advertisement

loading

Summary of Contents for Prestige APS-45C

  • Page 1 Model APS-45C Owner's Manual 4 Button Remote Keyless Entry System With Two Auxiliary Outputs FEATURES:  2 Four Button, RF Transmitters  Four Channel Code Learning Receiver  Remote Panic In All Modes  Built-In Parking Light Relay  LED Status Indicator ...
  • Page 2 Your Keyless Entry System has many features and available options some of which must be selected at time of installation. For your reference, the list on the back page of this manual shows what features and options have been installed with this particular system. Consult your install- ing dealer for options that may have been installed and are not listed.
  • Page 3: Remote Panic Operation

    The doors will unlock, the parking lights will flash twice and the dash mounted LED will turn off, confirming that the system is disarmed. The vehicle horn (or optional siren) will not chirp. If you have the optional entry illumination circuit installed, the interior light will turn on for 30 seconds or until the ignition key is switched on.
  • Page 4 panic feature, press and hold the lock or unlock button of your keychain transmitter for 3 seconds. This will cause the lights to flash, the vehicle horn (or optional siren) to sound, and if the optional interior illumination circuit was installed, the interior lights to flash. The panic mode will continue for 30 seconds and then reset.
  • Page 5: Programming Transmitters

    TWO STEP UNLOCK (ACCESS GUARD) By pressing the unlock button of the keychain transmitter as you would normally, (Please see the section titled "Unlocking The System", earlier in this manual), the system will disarm, and only the driver's door will unlock. If however, you should then decide instead that you want all doors to unlock, you can simply press the unlock button a second time and all doors will unlock.
  • Page 6: Battery Replacement

    DELETING TRANSMITTERS FROM YOUR SYSTEM: It may be necessary to delete a lost transmitter or to reprioritize a transmitter that is programmed to your system. To remove a transmitter that has been programmed in your system: 1) Enter the transmitter program mode of channel 1 as indicated above. 2) Press and hold any transmitter button that has not been programmed into channel 1 until you hear a chirp, then release and immediately press the same button a second time until you hear a long chirp followed by a short chirp.
  • Page 7 APS-45C SYSTEM FUNCTIONS AT A GLANCE LED INDICATORS: RAPID FLASHING PASSIVE ARMING SLOW FLASHING ARMED DISARMED ON SOLID VALET MODE OPTIONAL VEHICLE HORN OR SIREN CHIRP INDICATION: 1 CHIRP LOCK / ARM 2 CHIRPS UNLOCK / DISARMED CONTINUOUS PANIC MODE...
  • Page 8 To purchase replacement transmitters or to get additional product information go to: www.prestigecarsecurity.com This device complies with FCC Rules Part 15 Operation is subject to the following two conditions (1) This device may not cause harmful interference and (2) This device must accept any interference that may be received, including interference that may cause undesired operation.