Table of Contents
Advertisement
All manuals and user guides at all-guides.com
Check Rotating Floor Brush and Drive Belt
You should check your vacuum cleaner's Rotating
Floor Brush and Drive Belt regularly for wear or
damage. You should also clean the brush and brush
ends of strings, hair, and carpet fibers. These can
wrap around the brush and hamper its ability to
effectively clean your carpet. Also remove any debris
that has accumulated under the brush cover.
Unplug cleaner from electrical outlet.
1.
Place handle in Low position and turn vacuum cleaner over
2.
so bottom side is up.
Lift tab 1 and release the three latches in order 2-4 as
3.
marked. Lift the Brush Cover off.
Grasp Rotating Floor Brush at both ends and lift.
4.
Clean strings, hair and other debris from Rotating Floor
5.
Brush, paying particular attention to brush ends.
Clean strings, hair and other debris from Motor Pulley and
6.
Drive Belt areas.
Check Drive Belt carefully for wear, cuts or stressed areas.
7.
Check Air Passageway for obstructions. Remove debris
8.
from this area.
Replace Drive Belt
Use only BISSELL Style 10 Replacement Belts (#32074)
in your BISSELL PowerForce Bagless.
Unplug cleaner from electrical outlet.
1.
With Rotating Floor Brush removed from vacuum cleaner
2.
(Steps 1-4 of Check Rotating Floor Brush and Drive Belt),
grasp old Drive Belt and remove from Motor Pulley. Discard
old Drive Belt.
Place new Drive Belt over Motor Pulley and stretch other
3.
end over Rotating Floor Brush in the space between
the bristles.
Place ends of Rotating Floor Brush down into slots on sides
4.
as shown.
Turn Rotating Floor Brush by hand several times in the
5.
direction of Motor Pulley. If properly installed, Drive Belt will
center itself on Rotating Brush.
Reposition Brush Cover and snap back into place. Check to
6.
be sure all three latches are secured.
10
4
Motor Pulley
Air Passageway
Advertisement
Table of Contents
