Quick Call Ii (Astro P25 Digital Trunking And Conventional); Initiating A Quick Call Ii Transmission; Emergency Operation - Motorola APX 6000XE User Manual

Quick Call II (ASTRO P25 Digital
Trunking and Conventional)
This feature allows the user to broadcast a series of
distinct, recognizable tones before a voice transmission
from the dispatcher or a radio.
The broadcasting dispatcher or radio user can select this
alert tone transmission to be sent to an individual
Talkgroup or over the entire system. Specific tone or series
of tones are pre-programmed into the radios to allow the
dispatcher or supervisor to select a list of tones to
broadcast before they make their voice transmission. Each
tone is distinctive to indicate different situation or different
broadcaster. The transmitting radio also plays back the
tones for the broadcaster to listen.
NOTICE:
The receiving radios must be configured with the
Quick Call II tone in order for the radio to sound the
selected tone and also to sound a preconfigured
alert tone after the selected tone has sound.

Initiating a Quick Call II Transmission

The broadcasting or transmitting radio must be pre-
programmed to see the tone in the Quick Call II tone list.
Send Feedback
The receiving radio must also be pre-programmed to
decode the tone to broadcast.
1
or to QCII, and press the Menu Select button
directly below QCII.
2 or to select the tone to broadcast.
3 Press the PTT to broadcast the selected tone, or
press and hold the PTT to broadcast the selected
tone and transmit with your vocal transmission.
You hear the radio sounds the selected tone. You
can begin your call after the tone ends.
4 Release PTT to listen.

Emergency Operation

The Emergency feature is used to indicate a critical
situation.
If the Top (Orange) button is preprogrammed to send an
emergency signal, this signal overrides any other
communication over the selected channel.
Your radio supports the following Emergency modes:
English
91