Table of Contents
Advertisement
Maintenance and Service
●
Others
Problem
Remote controller does not work.
LCD TV makes strange noise.
LCD TV indication lamp is on.
Had forgotten Password of V-Chip
Can not select PC mode when D-sub
cable is connected to the RGB output
of Set-top-box.
This LCD TV is for household use and registered as suitable on electromagnetic waves.
Therefore, you can use it in every location as well as residential areas.
●
Supporting display mode
Resolution
Horizontal Frequency (KHz)
640×480
720×400
800×600
1024×768
1280×1024
●
Considerations in Installation
If any signal of unsupported resolution is input, the "Out of Range" message appears.
Trouble shooting Tips
Action
1. Check if main power is on.
2. Check that the batteries of the remote controller were
loaded properly.
3. Check to see if any obstacle exists between the LCD
TV and the remote controller and remove it, if any.
4. If the batteries have no power, replace them with two
new batteries.
It is the noise when the mechanism expands or contracts
from to changes to the environment due to factors such
as humidity, temperature, etc. It is not a failure.
The red means the Stand-by power is on. It will take a few
seconds to turn off as the main power is off.
,
,
,
,
Press
in V-Chip function.
D-sub cable must not meet VESA standard. (D-sub No. 10
pin must be grounded) Component cable can be used if
there is an Component terminal.(See Page 18)
Vertical Frequency (Hz)
31.47
37.86
37.50
31.47
35.15
48.88
46.88
48.36
56.48
60.02
64.0
buttons on the Remotecontrol
60
72
75
70
56
72
75
60
70
75
60
4 3
Advertisement
Table of Contents
