Editing Factory Programs - dbx DriveRack 240 User Manual

DriveRack
Navigation Modes
Once you have selected a program that utilizes a configuration that accommodates your appli-
cation, the DriveRack™ offers instant access to edit effect types within the selected configura-
tion.
To instantly access an effect module, simply press the corresponding button in the button array
for the desired module. The following buttons will access the following modules: PRE-EQ =
PEQ or GEQ modules prior to the crossover section. X-OVER = Crossover(s) and filters,
DELAY = Delay and Driver Alignment Delay (successive presses will you move through each
input and output which utilizes the Delay type module). DYNAMICS = Compressor/Limiter
(successive presses will move you through each output compressor module. POST EQ = PEQ
modules after the crossover section).
Once you have reached the module that you wish to edit, simply use the
PREV PG and NEXT PG buttons to move through the pages within the module. The DATA
wheel is used to edit parameter values. The following illustration shows an example of the
Dynamics module in edit mode:
Note that the underscore indicates the currently selected parameter for editing. To select para-
meters to edit from the current page, simply press the DATA wheel until the underscore is
under the parameter that you wish to edit.
®
™
Configuring the DriveRack™

3.3 Editing Factory Programs

Out1 DynamicsOFF
Comp OverEasyOFF
Section 3
DriveRack™ User Manual
13