Table of Contents
Advertisement
When you are using the S VIDEO plug,
make sure the red and white plugs of the A/V
connecting cable are connected (p. 40).
The top, bottom, right, and left edges
of images are trimmed slightly on a
connected TV.
The LCD screen of your camcorder can
display recording images across the entire
screen (full pixel display). However, this may
cause slight trimming of the top, bottom, right,
and left edges of images when played back on
a TV which is not compatible with full pixel
display.
It is recommended you record images using
the outer frame of [Safety Zone] (p. 88) as a
guide.
The image appears distorted on the 4:3
TV.
This happens when viewing an image
recorded in the 16:9 (wide) mode on a 4:3 TV.
Set [Down Convert Type] correctly (p. 93) and
play back the image.
Black bands appear at the top and bottom
of the screen of the 4:3 TV.
This happens when viewing an image recorded
in the 16:9 (wide) mode on a 4:3 TV. This is
not a malfunction.
Copying/Connecting to other
devices
Images are not copied correctly.
You cannot copy images using the HDMI
cable (sold separately).
The A/V connecting cable is not connected
properly. Make sure to connect the cable to the
input jack of another device (p. 70).
GB
10
Connecting to a computer
The computer does not recognize the
camcorder.
Disconnect the cable from the computer, and
then connect it again securely.
Disconnect the cable from the computer,
restart the computer, and then connect the
computer to your camcorder correctly.
Movies cannot be viewed or copied to a
computer.
Disconnect the cable from the computer, and
then connect it again.
You need to install the supplied "Content
Management Utility" to copy movies from
your camcorder to your computer (p. 72).
The computer freezes.
Disconnect the cable from your computer
and camcorder. Reboot your computer,
and connect your computer and camcorder
following the steps in the correct order.
Advertisement
Table of Contents
