Table of Contents
Advertisement
2.9
Audio Settings Page
The Audio Settings page allows the administrator to adjust specific device properties not covered in
other configuration pages such as master volume settings and other feature settings. See Figure
10.
Figure 12
•
Channel VU's – Allows the administrator to look at channel activity of all 12 channels.
•
Audio Settings – Allows the administrator to adjust master speaker volume & microphone gain of
device. Speaker & microphone level meters are provided as simple diagnostic tools to confirm
if the device is working properly. Master volume level and Mic Volume are default to set to 80.
•
Test Speaker – Pressing this button plays a test message on the device.
•
Start Announcement – If this box is checked the device will play a message indicating it is being
restarted any time the device experiences a reload or reboot.
•
Use VAD – If this box is checked the device will stop producing RTP audio packets after 6
seconds of no voice while PTT is pressed. If unchecked, the device will continuously produce
RTP audio packets when PTT is pressed even if the user is still speaking.
•
PTT Mutes Speaker – If this box is checked the speaker will be muted when PTT is pressed on
any channel. If unchecked the device is in full duplex mode on respective PTT channel.
•
Headset Only – Checking this box enables the use of a headset without a PTT button. All PTT
operation is done with the PTT knobs.
•
Footswitch – Checking this box enables use of a foot switch to activate PTT function of a selected
channel. In this mode the buttons on the front panel are used to select a channel for which the
footswitch will activate the PTT.
•
Group Call - Enabling this feature allows the user to transmit ("Broadcast") on 2 or more channels
at the same time. User presses the F1 button then presses each respective channel button to
select channels for 'simulcast' which will be indicated by a check mark next to each selected
channel name. When done selecting channels, user simply presses the volume knob/PTT
button of one of the selected channels to transmit on all selected channels. Pressing F1 again
will exit the Group Select mode.
•
RX Indication Delay (seconds) – Extends incoming audio indication by the number of configured
seconds.
CS-812 Administration and Set Up Guide
Page 16
Essential Trading Systems Corp.
Advertisement
Table of Contents
