Specifications - Makita 9565CLR Instruction Manual

ENGLISH (Original instructions)
1-1. Shaft lock
2-1. Slide switch
3-1. Indication lamp
(speed adjusting dial)
4-1. Speed adjusting dial
7-1. Abrasive disc
7-2. Pad
7-3. Spindle
9-1. Head cover
9-2. Gear housing
10-1. Screw
12-1. Wheel guard
12-2. Bearing box

SPECIFICATIONS

Max. wheel thickness
Rated speed (n) / No load speed (n
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Explanation of general view
12-3. Screw
13-1. Lock nut
13-2. Depressed center grinding
13-3. Inner flange
14-1. Lock nut wrench
14-2. Shaft lock
15-1. Lock nut
15-2. Abrasive disc
15-3. Rubber pad
16-1. Marking A
17-1. Marking B
18-1. Marking C
Model
Abrasive disc
Spindle thread
)
o
Overall length
Net weight
Safety class
noise level determined
) : 86 dB (A)
pA
) : 97 dB (A)
WA
value (tri-axial vector
wheel/Multi-disc
ENE048-1
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
ENF002-2
Work mode: disc sanding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENG905-1
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
The declared vibration emission value is used for
•
main applications of the power tool. However if the
power tool is used for other applications, the
vibration emission value may be different.
WARNING:
The vibration emission during actual use of the
•
ENG900-1
power tool can differ from the declared emission
sum) value depending on the ways in which the tool is
used.
4
19-1. Pin
19-2. Vent
21-1. Wire cup brush/Wire bevel brush
22-1. Lock nut
22-2. Abrasive cut-off wheel/
diamond wheel
22-3. Inner flange
22-4. Wheel guard for abrasive cut-off
wheel/diamond wheel
23-1. Exhaust vent
23-2. Inhalation vent
9565CLR
125 mm
6.4 mm
M14
-1
7,800 min
311 mm
2.1 kg
/II
2
) : 4.5 m/s
h,AG
2
2
) : 2.5 m/s or less
h,DS
2
ENG902-1