Power Button Assembly With Fingerprint Reader; Removing The Power Button Board Assembly With Fingerprint Reader - Dell P93F Service Manual

Steps
1. Place the power button into its slot on the computer.
2. Replace the two (M2x3) screws to secure the power button in place.
Next steps
1. Install the power button
2. Install the heat-sink assembly.
3. Install the battery.
4. Install the base cover.
5. Install the SD card.
6. Follow the procedure in

Power button assembly with fingerprint reader

Removing the power button board assembly with fingerprint reader

Prerequisites
1. Follow the procedure in
2. Remove the SD card.
3. Remove the base cover.
4. Remove the battery.
5. Remove the heat-sink
About this task
The figure indicates the location of the power button board assembly with fingerprint reader and provides a visual
representation of the removal procedure.
66 Removing and installing components
board.
after working inside your
before working inside your
assembly.
computer.
computer.