Smart-Card Reader; Removing The Smart-Card Reader - Dell P93F Service Manual

4. Install the battery.
5. Install the base cover.
6. Install the SD card.
7. Follow the procedure in

Smart-card reader

Removing the smart-card reader

Prerequisites
1. Follow the procedure in
2. Remove the SD card.
3. Remove the base cover.
4. Remove the battery.
5. Remove the WLAN card.
6. Remove the WWAN card.
7. Remove the primary M.2
8. Remove the inner frame.
About this task
The figure indicates the location of the smart-card reader and provides a visual representation of the removal procedure.
Steps
1. Disconnect the touchpad buttons FPC from the touchpad.
2. Disconnect the smart-card reader FFC from the connector on the USH daughter board.
3. Peel the smart-card reader FFC from the touchpad.
4. Remove the two (M2x2.5) screws that secure the smart-card reader to the computer.
5. Remove the smart-card reader from the computer.
52 Removing and installing components
after working inside your
before working inside your
SSD.
computer.
computer.