Table of Contents
Advertisement
1.5 Connection to a preamplifier or integrated amplifier
Connect the analogue outputs (16-19) to the high-level inputs of a preamplifier or integrated
amplifier. The RCA-cinch outputs and the balanced XLR outputs are fully decoupled from
each other and can be used independently.
1.6 Connection of digital signal sources
Digital signal sources
Connect the outputs of your digital sources to the corresponding inputs of your device:
- Optical inputs (23, 24)
- Coaxial inputs (25, 26)
- USB B input (22)
- AES/EBU input (27)
Digital input sources
The input of a digital recorder must be connected to the digital outputs (20, 21). The signal on
the digital outputs depends on the selected source (e.g. DIG COAX, DIG OPT).
PLEASE NOTE: Incoming signals via the USB-B input (22) are not looped through the digital
outputs (20, 21).
1.7 RC 9 remote control
The optionally available RC 9 remote control allows for easy and comprehensive control of
your devices. Before you can use the RC 9 together with your device, both components need
to be connected. This process is also referred to as Pairing. In order to start the pairing
process, please follow the instructions as described in section 1.7.1. A detailed description of
the entire functionality of the optionally available RC 9 remote control can be found in a
separate manual on the product page of our AVM website at www.avm.audio.
1.7.1
Pairing
In order to control your device with a RC 9 remote control, both components need to be
linked first. This process is also referred to as Pairing. To start the pairing process, please
switch off your device by using the mains switch (30) on the rear side of the unit. Now please
navigate to the Systems Settings menu on your RC 9 remote control by pressing the
Settings key and navigate to the menu item Start Pairing without selecting it with the Enter
key yet. Switch on your device by using the mains switch (30) on the rear side of the unit and
immediately press the Enter key of your RC 9 remote control to now start the Pairing
process. The name of a succesfully detected device will instantaneously be shown on the
display of your RC 9 remote control and can be edited by using the alphanumeric input keys
of the RC 9 remote control. After confirming the name of the paired device with the Enter
key, you can also choose one of four available Hotkeys. Details on how to use the Hotkey
8
Advertisement
Table of Contents
