Connection To A Preamplifier Or Integrated Amplifier; Connection Of Digital Signal Sources; Rc 3 Remote Control - AVM OVATION CD 6.2 Operating Instructions Manual

Hide thumbs Also See for OVATION CD 6.2:

Table of Contents

1.5 Connection to a preamplifier or integrated amplifier

Connect the analogue outputs (16-19) to the high-level inputs of a preamplifier or integrated

amplifier. The RCA-cinch outputs and the balanced XLR outputs are fully decoupled from

each other and can be used independently.

Digital signal sources

Connect the outputs of your digital sources to the corresponding inputs of the CD 6.2:

- Optical inputs (23,24)

- Coaxial inputs (25,26)

- USB B input (22)

- AES/EBU input (27)

Digital input sources

The input of a digital recorder must be connected to the digital outputs (20, 21). The signal on

the digital outputs depends on the selected source (e.g. DIG COAX, DIG OPT).

The included RC 3 remote control allows for easy and comprehensive control of the CD 6.2.

All main functions of the CD 6.2 can be controlled by the RC 3: On/Off, Source Selection,

Station Selection, SKIP, PLAY/PAUSE, and STOP.

By pressing the PLAY button briefly a second time, the PAUSE function is activated while in

CD mode. By pressing the STOP button briefly a second time, an inserted CD is ejected. By

holding down one of the SKIP buttons a little longer, the device switches into seek mode

(Fast Forward/Reverse).

If there is no CD inserted or the CD is not in playback mode, you can switch between the

different digital inputs by pressing the STATION buttons of the RC 3. Press PLAY to return to

CD mode.

If a variable output level has been activated in the personal setup menu (see 3.1.1), you can

control the output level of the analogue outputs of your CD 3.2 / CD 5.2 by pressing the

VOLUME buttons on your RC 3 remote control (see also 2.6).

Table of Contents