Advanced Settings; Personal Setup - AVM OVATION MP 8.2 Operating Instructions Manual

Table of Contents

Advertisement

Below the LO RES and HI RES indication, the currently active data format is shown on the
display (PCM or DSD).
Please note that you need to select the HI RES mode in order to play back DSD64 or
DSD128 files.

3 Advanced Settings

3.1 Personal Setup

The personal setup offers a range of settings to individualize tyour device according to your
personal needs. To enter the personal setup menu, please switch off your device on the rear
of the unit at the mains switch (35). Keep the PROG button pressed (4) while you switch on
the unit again (35). As soon as the display shows the personal setup menu you can release
the PROG button (4).
When the personal setup is active, you can select the desired function using the option keys
(2, 3). Use the SKIP buttons (13, 14) to apply changes to a selected function. EXIT (STOP
button) exits the personal setup and stores all settings.
3.1.1
Set volume control
Gain fix
If the gain fix option is activated, the signal of the selected sound source will be played back
with a fixed volume level. This setting is particularly useful when your device is part of a
surround sound setup where a separate surround decoder is used for bass and multi-channel
management. If a surround system is connected to your device, specific settings such as
channel balance, tone settings and bass management are controlled by a separate decoder.
These settings may not be altered by other components in order to maintain the balance of all
channels. For this application, your device offers the gain fix function by passing through the
signal with a fixed gain setting (see below).
Gain variable
If the option Gain variable is activated, the playback volume can be controlled in steps of 0,5
dB by holding down one of the option keys on the front side of the unit (2, 3) for more than
one second. The current volume level is shown in the range of 0 to 100 dB in the upper part
of the display (see also section 2.6).
3.1.2
set display brightness
Sets display brightness 25% to 100%.
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ovation mp 6.2

Table of Contents