Table of Contents
Advertisement
3 Advanced settings
3.1 Personal setup menu
The personal setup offers you a range of settings to individualize the device according to your personal
needs. To enter the personal setup menu, please switch off your device on the rear of the unit at the
mains switch (29). Keep the PROG button (4) pressed while you switch on the unit again. As soon as
the display shows *** personal setup *** menu you can release the PROG button (4).
When the personal setup is active you can select the desired function using the option keys (2, 3). Use
the Skip buttons (13, 14) to apply changes to a selected function. EXIT exits the personal setup and
stores the settings.
3.1.1 Volume control
Choose between a fixed ("fixelevel") or a variable ("variable") output level of the analogue outputs (16-
18). If "variable" is selected, the output level of the analogue outputs of your CD 3.2 or CD 5.2 can be
controlled by pressing the VOLUME buttons on your RC 3 remote control. In standard operating mode
an information on the current output level state is displayed in the upper-middle part of the display (e.g.
VOL 75). FIX indicates a fixed output level setting.
3.1.2 Display brightness
Sets display brightness between 25% and 100%.
NOTE: The setting 100% can lead to "burn in" effects on the display if the unit is operated in this
setting for a very long time. So please switch the unit to stand by, if not in use.
3.1.3 Set autoplay
When AUTOPLAY is ON, your CD player will start playing automatically every time a new CD is
inserted. If AUTOPLAY is OFF, the unit will read the TOC (Table Of Content) of the inserted disc and
then go to STOP mode.
3.1.4 Skip unused inputs
Deactivate unused inputs ("SKIP"). The unit will then skip these inputs when the option keys are
pressed (2, 3) or if you select the inputs via the RC 3 remote control.
3.1.5 Define input names
You can individually set the names (max. 8 characters) of the different sources shown in the display (8).
Proceed as follows:
Press < or > (2,3) to select the input. Press REPEAT (6) to select the position and I<< or >>I (13,14) to
define the character (holding the key pressed changes the character every half second).
11
Advertisement
Table of Contents
