H-Tronic HTC 2000 Manual page 27

• Then connect the battery charger to the mains. The LED 1 mains ("Netz") will
light up.
• Press the "Mode" button within 5 seconds until the desired function (Pb / Li-Ion)
is selected.
• If the battery is connected with the correct polarity, not defective (high-resis-
tance/connection interrupted) and the mains supply is available, the charging
process will start after a few seconds (LED 2 charging ("Laden").
• Charging times can vary in length. Depending on the capacity and condition
of the battery, charging may take several hours or days.
• The charging process is finished when LED 5 finished ("Fertig") lights up
permanently.
If the charging process does not start, the fuse could possibly be defective.
In this case, replace the fuse and check the wiring.
When using a permanent connection, make sure that neither the charger nor the
charging cable connections are exposed to moisture. The operation of the char-
ger when installed (permanent connection in the vehicle) is only permitted in dry,
closed rooms (such as a garage). If the charger is not connected to a mains sup-
ply, a low reverse current will flow and gradually discharge the battery. We re-
commend the permanent connection only for vehicles that are moved and
charged regularly.
• After charging, first disconnect the charger from the mains.
THE FOLLOWING SEQUENCE FOR DISCONNECTING THE
CHARGING TERMINALS MUST BE FOLLOWED:
1. First disconnect the black charging clamp (negative) from the vehicle chassis
or the engine block.
2. Then disconnect the red terminal (positive) from the positive pole of the
battery.
ABORTING THE CHARGING PROCESS
A charging process can be interrupted at any time. Before disconnecting the
battery from the charger, always disconnect the charger from the mains.
Automatic Charger HTC 2000
| 27