Titan TTLMP300SP40 Manual page 12

Before you start
1. Place the product on a stable, level surface. We recommend laying a non-flammable
sheet under the product.
2. Unscrew and remove the fuel tank cap (11) (Fig. 7).
7
3. Add suitable fuel into the fuel tank. Leave a minimum 5 mm of space between
the top of the fuel and the inside edge of the tank to allow for expansion (Fig. 8).
8
4. Wipe any spilt fuel with a soft cloth and reattach the fuel tank cap (11).
NOTE: Petrol deteriorates over time. It may be difficult to start the engine if
you use petrol which has been kept for more than few days. Empty the fuel
after every use. Run the product dry of fuel in idle before storage.
NOTE: Fuel can damage paint and plastic. When filling the tank, take care not
to spill any fuel. Damages caused by spills are not covered by the guarantee.
22
TTLMP300SP40
11
5 mm
TTLMP300SP40
Engine oil
WARNING! This product is not supplied with oil. However, for manufacturing
reasons, it is possible that a small quantity may be in the engine! Before
operating this product, it is essential to fill it with oil (4-stroke engine oil, e.g.
SAE 10W-30)!
Engine oil has a significant influence on engine performance and service life.
Non-detergent or 2-cycle engine oils will damage the engine and should not
be used - see the separate operator's manual of the BRIGGS&STRATTON
engine (30).
1. Place the product on a flat and even surface.
2. Unscrew and remove the oil tank cap (18).
3. Gradually add good-quality engine oil (SAE 10W-30). Allow the oil to settle.
4. Check the oil level frequently while filling. Wipe off oil dipstick and insert it into
the tank opening without tightening the cap, and then remove the dipstick again.
5. The oil level must be between the oil level markings (approx. 400 ml). Add more
oil if necessary. Do not overfill (Fig. 9).
9
18
6. After filling oil, wait 1 minute and then recheck the oil level.
7. Wipe the spilt oil with a soft cloth and reattach the oil tank cap (18).
Before you start
máx
5 mm
mín
23