Table of Contents
Advertisement
Installing the Device
2.1 General Procedure
2.1
General Procedure
The general procedure for installing the device is as follows:
The user is responsible for the operating environment of the device, including
maintaining the integrity of all protective conductor connections and checking
equipment ratings. Make sure to review all operating and installation instructions
before commissioning or performing maintenance on the device.
1.
2.
3.
4.
5.
2.2
Unpacking the Device
When unpacking the device, do the following:
1.
2.
3.
Note
If any item is missing or damaged, contact Siemens for assistance.
2.3
Mounting the Device
The RUGGEDCOM RMC8388 is designed for maximum mounting and display
flexibility. It can be equipped with connectors that allow it to be installed in a 35 mm
(1.4 in) DIN rail or directly on a panel.
10
NOTICE
Review the relevant certification information for any regulatory
requirements.
For more information, refer to
Unpack and inspect the device.
For more information, refer to
Mount the device.
For more information, refer to
Connect power and ground the device.
For more information, refer to
Configure the device.
For more information, refer to
Inspect the package for damage before opening it.
Visually inspect each item in the package for any physical damage.
Verify all items are included.
"Approvals" (Page
31).
"Unpacking the Device" (Page
"Mounting the Device" (Page
"Connecting Power" (Page
"Configuring the Device" (Page
Installation Manual, 11/2022, C79000-G8976-1188-05
10).
10).
14).
20).
RUGGEDCOM RMC8388
Advertisement
Table of Contents
