Table of Contents
Advertisement
5
6
7
8
9
10
Figure 1.1
POWER LED
SYNC LED
LINK/ACT LED
RS232 Serial Console Port
Power Supply Terminal
BNC Port(s)
Fiber Optic or Copper Ethernet
Port
RUGGEDCOM RMC8388
Installation Manual, 11/2022, C79000-G8976-1188-05
BNC Ports – TTL OUT1/2
BNC Port – AM OUT
BNC Port – AM IN
Copper Ethernet Port with LINK/ACT LED
Copper FastConnect Ethernet Port with LINK/ACT LED
Fiber Optic Ethernet Port with LINK/ACT LED
RUGGEDCOM RMC8388
Illuminates when power is being supplied to the device.
State
Green
Red
Off
Indicates the status of the supplied timing signal.
State
Green
Amber/Yellow
Red
Off
Indicates the state of the copper or fiber optic Ethernet port.
State
Green (Solid)
Green (Blinking)
Off
For interfacing directly with the device and accessing initial
management functions. For information about connecting to
the device via the serial console port, refer to
Device" (Page
19).
A pluggable terminal. For more information, refer to:
•
"Connecting Power" (Page 14)
•
"Power Supply Specifications" (Page 25)
Transmits/receives timing signals from one protocol to another.
For more information about the individual BNC ports, refer to
Ports" (Page
21).
Receives and transmits IEEE 1588 v2 messages, as well as provides
remote Web access to the RUGGEDCOM ROS operating system. For
more information, refer to:
•
"Connecting to the Device" (Page 19)
•
"Copper Ethernet Port (If Equipped)" (Page 23)
•
"Fiber Optic Ethernet Port (If Equipped)" (Page 22)
Introduction
1.2 Description
Description
Device is ready
Device is booting up
No power
Description
Signal locked
Holdover
Error
No signal detected
Description
Link established
Link activity
No link detected
"Connecting to the
"BNC
3
Advertisement
Table of Contents
