Toyota Land Cruiser 200 2018 Manual page 549

Starting the engine
1
Ensure that the shift lever is in P and depress the brake pedal.
2
Touch the area behind the but-
tons on the electronic key to the
engine switch.
When the
detected, a buzzer sounds and the
engine switch will turn to IGNITION
ON mode.
When the smart key system is
deactivated in customization set-
ting, the engine switch will turn to
ACCESSORY mode.
3
Firmly depress the brake pedal and check that
the multi-information display.
4
Press the engine switch.
In the event that the engine still cannot be started, contact your Toyota
dealer.
■
Stopping the engine
Shift the shift lever to P and press the engine switch as you normally do when
stopping the engine.
■
Replacing the key battery
As the above procedure is a temporary measure, it is recommended that the
electronic key battery be replaced immediately when the battery is depleted.
(→P. 487)
■
Alarm
Using the mechanical key to lock the doors will not set the alarm system.
If a door is unlocked using the mechanical key when the alarm system is set,
the alarm may be triggered. (→P. 75)
■
Changing engine switch modes
Release the brake pedal and press the engine switch in
engine does not start and modes will be changed each time the switch is
pressed. (→P. 200)
■
When the electronic key does not work properly
●
Make sure that the smart key system has not been deactivated in the cus-
tomization setting. If it is off, turn the function on.
(Customizable features: →P. 582)
●
Check if battery-saving mode is set. If it is set, cancel the function.
(→P. 128)
LC200_OM_OM60Q26U_(U)
7-2. Steps to take in an emergency
electronic key is
549
is shown on
3
step above. The
7