Table of Contents
Advertisement
544
7-2. Steps to take in an emergency
2
Install
the
inserting the claw into the wheel
lug nut hole. Turn the jack han-
dle extension clockwise to take
up slack in the chain.
Then, check to ensure the claw is
in the wheel lug nut hole and the
holding bracket is centered in the
wheel hub.
1
Holding bracket
2
Claw
3
Raise the tire.
While
raising,
towards the rear of the vehicle,
taking care that the tire goes up
without catching on any sur-
rounding part, to prevent it from
flying forward during a collision or
sudden braking.
After the tire goes half way up,
check that the suspended chain
is able to enter the tire hole, for
proper storage.
Tightening torque:
33.2 ft•lbf (45 N•m, 4.6 kgf•m)
4
Confirm that the tire is not loose
after tightening:
1
Push and pull the tire
2
Try rotating
Visually check to ensure the
tire is not hung on surrounding
parts.
If looseness or misassembly exists, repeat step
5
Repeat step
LC200_OM_OM60Q26U_(U)
holding
bracket,
pull
the
tire
4
, any time the tire is lowered or disturbed.
incorrect
correct
3
and step
4
.
Advertisement
Table of Contents
