Table of Contents
Advertisement
Operating the product
2. Display Information Line will show
"CL 3", "CL 2", "CL 1" and " CL On".
Canceling a programme
1. Press Start / Pause / Cancel key for 3
seconds to cancel the programme.
2. Release the key when the Start / Pause
indicator starts flashing. For a couple
of minutes the machine will fulfill the
necessary operations required to cancel
the programme.
C
You can select and operate a
new programme following the
cancellation of the programme.
C
There might be residues of
detergent or rinse aid left in the
machine and / or on the pieces
being washed depending on the
step the programme you have
cancelled was in.
Changing a programme
To change a running programme, you
should cancel the programme in the first
place. Then, you can select and start a new
programme.
Volume setting
Your machine is equipped with a Buzzer to
inform warnings audibly.
When the Volume Level key is pressed and
hold for 3 seconds to adjust the volume level,
Volume Level indicator will light and the
Buzzer will play the opening melody in the
same volume set. At the moment of first press,
current key tune will be played. First line and
the speaker icon will light for low volume.
3 lines altogether and the speaker icon will
light for high volume. Volume Level indicator
will go off after 3 seconds.
28
/40 EN
Salt indicator ( )
Please check the salt indicator on the display
to see whether there is adequate amount
of softening salt in the dishwasher or not.
You need to refill the salt reservoir with salt
whenever salt warning indicator appears on
the display of your machine.
C
Adjusting the water hardness
level is explained in Water
Softening System section.
Rinse Aid indicator ( )
Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or
not. You need to refill the rinse aid reservoir
with rinse aid whenever rinse aid warning
indicator appears on the display of your
machine.
Water Cut-off indicator (
Water Cut-off warning indicator will light
when the machine cannot take in water.
When the water is supplied again, warning
light will be turned off automatically.
A
Make sure that the water is
not cut-off and the tap is not
closed when the Water Cut-off
warning light is illuminated. Call
Authorised Service Agent if
water is not cut-off and the tap is
open.
End of programme
End of Programme indicator will light up
once the washing programme is over.
1. Press On / Off key to turn off your
machine.
2. Close the tap.
3. Unplug the machine from the socket.
DISHWASHER / USER INSTRUCTIONS
)
Advertisement
Table of Contents
