WKUP
This pin is connected to the WKUP pin of the CPU. It is used to wake up the CPU is in shutdown mode.
For more information, please refer to the ATSAMA5D44 datasheet:
http://www.atmel.com/devices/ATSAMA5D44.aspx
#RESET
General reset of the board, active low. Keep this pin low (#RESET < 1V) for at least 1ns to reset the board.
This pin has an internal pullup of 100K to 3.3V power supply. Can be left unconnected if reset control is not
needed.
ADCREF_EXT
Not connected in current DevelBoard Blue version. Currently ADCVREF of the CPU is connected to the
3.3V power supply. For normal operation leave this pin unconnected.
BOOT_RECOVERY
For normal operation, this pin can be driven low or left unconnected. If driven high, this pin disables the CE
input of the onboard flash memory. This is useful to prevent the CPU from booting from the onboard flash if
something goes wrong during development or if you want the CPU to boot from other devices.
D evelerBoard Blue
Hardware Reference Manual
https://www.develboard.com
Pag. 15/30