10 Troubleshooting And Maintenance; Troubleshooting Using The Sct; Table 35 - Accessing Smv 800 Diagnostic Information Using The Sct - Honeywell SmartLine Multivariable SMV800 Series User Manual

10 Troubleshooting and Maintenance

Troubleshooting Using the SCT

Using the SCT in the on-line mode you can check the transmitter status, identify diagnostic messages
and access troubleshooting information so you can clear fault conditions.
The SMV diagnostic messages fall into any one of the following general categories:

Status (Informational)

Noncritical Status

Critical Status

Communications
Follow the steps in Table 35
procedures for clearing transmitter fault conditions.

Table 35 - Accessing SMV 800 Diagnostic Information using the SCT

Step
Connect the SCT to the SMV and establish communications. (See
1
Section 0
necessary.)
Select the Status Tab Card (if not selected already) to display a
2
listing of the Gross Status and Detailed Status messages.
Refer to the SCT on-line user manual for descriptions of the status
3
messages and corrective actions to clear faults.
ATTENTION
When critical status forces PV output into failsafe condition, record the messages before you cycle
transmitter power OFF/ON to clear failsafe condition.
For more information on trouble shooting the SCT refer to the SCT manual, #34-ST-10-08
Page 158
to access diagnostic messages generated by the SMV 800 and
Establishing Communications for the procedure, if
SMV800 Series HART/DE Option User's Manual
Action
Revision 6.0