Fitting Drill Bits And Accessories - Westfalia 93 56 33 Operating Instructions Manual

 The battery charger monitors battery temperature and voltage while
charging. Remove the battery once charging has been completed to
maximise charge cycles of the battery and not waste power.
 Batteries can become faulty over time, individual cells in the battery
can fail and the battery could short. The charger will not charge
faulty batteries. Use another battery, if possible, to check correct
functionality of the charger and purchase a replacement battery if a
faulty battery is indicated.
 Do not store Lithium-Ion battery packs in a discharged state long
term. This can damage the Lithium-Ion cells. For long-term storage,
store batteries in a high charge state disconnected from the power
tool.
 The capacity of batteries will reduce over time. After 100 charge
cycles, the battery's operation time and the maximum torque per-
formance of the tool will slightly reduce. This decline will continue
until the battery has minimal capacity after 500 charge cycles. This
is normal and not a fault with the battery pack.

Fitting Drill Bits and Accessories

WARNING: Always remove the battery from the combi drill before
attaching, adjusting or removing accessories.
WARNING: Do not attempt to tighten drill bits (or any other accessory)
by gripping the front part of the chuck and switching the tool on. This
can lead to personal injury and can cause damage to the chuck.
WARNING: Never fit any accessory or bit with a maximum speed lower
than the no load speed of the power tool.
1. Open the chuck jaws (1) by rotating the chuck collar (2) anti-
clockwise.
2. Place the drill bit or accessory centrally into the chuck.
3. Tighten the chuck jaws by rotating the chuck collar clockwise.
4. When the drill bit or accessory is securely fastened, carefully run the
machine to test that it is running centrally, smoothly and evenly. If
the bit is 'wobbling' or not running centrally, release the chuck, check
the accessory for damage, correct its position, retighten and test
again.
Operation
22