Switching On/Off; Use As Screwdriver; Drilling Masonry And Concrete - Westfalia 93 56 33 Operating Instructions Manual

Switching ON/OFF

WARNING: Always wear adequate personal protection equipment
when setting up and operating this machine.
To start the tool, squeeze the trigger switch (8).
Note: If the trigger switch cannot be pressed down, check that the
forward/reverse switch (7) is not set to its middle position, which locks
the device (see 'Direction control').
 The speed of the tool is controlled by the movement of the trigger,
the further the trigger switch is pressed down, the faster the tool will
run. The work light (10) lights up while the trigger switch (8) is
pressed.
 Release the trigger switch to stop the machine.

Use as Screwdriver

Note: Always use a universal bit holder when working with screwdriver
bits. Do not mount screwdriver bits directly into the chuck!
1. Select gear 1 using the gear switch (5).
2. Rotate the mode selector (4) to drive.
3. Adjust the combi drill to the appropriate torque setting (see 'Torque
Control').
 When driving screws never use the machine in drill mode.
Note: If in doubt which torque setting best suits the application, start
with a low setting and increase, should more torque be required (e.g. if
the screw is not being driven far enough into the workpiece).

Drilling Masonry and Concrete

1. Select gear 1 using the gear switch (5).
2. Rotate the mode selector (4) to the hammer drill position.
 Hammer drill mode should be used for drilling into masonry and
concrete.
 Apply moderate pressure to the rear of the tool, in line with the drill
bit.
 Use masonry drill bits only. Ensure that the bit size is within the
maximum capacity of the machine (see 'Technical Data').
Operation
24