Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Sentera Controls DSTHM-2
Summary of Contents for Sentera Controls DSTHM-2
- Page 1 DSTHM-2 COMBINED T AND RH DUCT TRANSMITTER Mounting and operating instructions...
-
Page 2: Table Of Contents
INTENDED AREA OF USE TECHNICAL DATA STANDARDS OPERATIONAL DIAGRAMS WIRING AND CONNECTIONS MOUNTING & OPERATING INSTRUCTIONS IN STEPS OPERATING INSTRUCTIONS VERIFICATION OF INSTALLATION TRANSPORT AND STOCK KEEPING INFORMATION WARRANTY AND RESTRICTIONS MAINTENANCE MIW-DSTHM-2-EN-000 - 05 / 05 / 2020 2 - 10 www.sentera.eu... -
Page 3: Safety And Precautions
In case there are any questions that are not answered, please contact your technical support or consult a professional. MIW-DSTHM-2-EN-000 - 05 / 05 / 2020 3 - 10 www.sentera.eu... -
Page 4: Product Description
COMBINED T AND RH DUCT TRANSMITTER PRODUCT DESCRIPTION The DSTHM-2 series are combined duct transmitters which measure temperature and relative humidity. Based on the temperature and relative humidity measurements, the dew point is calculated. They are Power over Modbus supplied and all parameters are accessible via Modbus RTU. -
Page 5: Operational Diagrams
Always use the flange to install the sensor on round ducts. It is possible to install the sensor without the flange on rectangular ducts (if necessary), see Fig. 1 and Fig. 2 below. MIW-DSTHM-2-EN-000 - 05 / 05 / 2020 5 - 10 www.sentera.eu... - Page 6 If you do not intend to use the flange, insert the probe and fix the enclosure onto the duct. Mind the airflow direction (see Fig. 2 and Fig. 3). MIW-DSTHM-2-EN-000 - 05 / 05 / 2020 6 - 10 www.sentera.eu...
- Page 7 Close the enclosure and secure it with the screws. Tighten the cable gland to retain the IP rating of the enclosure. Switch on the power supply. MIW-DSTHM-2-EN-000 - 05 / 05 / 2020 7 - 10 www.sentera.eu back to the table of contents...
-
Page 8: Operating Instructions
‘boot mode’ is automatically activated and the firmware can be updated. Make sure the power supply does not get interrupted during “bootload” procedure, NO T E otherwise you risk losing unsaved data. MIW-DSTHM-2-EN-000 - 05 / 05 / 2020 8 - 10 www.sentera.eu back to the table of contents... -
Page 9: Verification Of Installation
In case of heavy pollution, clean with a non-aggressive product. In these circumstances the unit should be disconnected from the supply. Pay attention that no fluids enter the unit. Only reconnect it to the supply when it is completely dry. MIW-DSTHM-2-EN-000 - 05 / 05 / 2020 9 - 10 www.sentera.eu... -
Page 10: Miw-Dsthm-2-En-000 - 05 / 05 / 2020 Www.sentera.eu
COMBINED T AND RH DUCT TRANSMITTER MIW-DSTHM-2-EN-000 - 05 / 05 / 2020 10 - 10 www.sentera.eu back to the table of contents...
Need help?
Do you have a question about the DSTHM-2 and is the answer not in the manual?
Questions and answers