Changing The Engine Oil And Filter - Toro 08743 Operator's Manual

Figure 24
1. Dipstick
5. Insert the dipstick into the tube and make sure
that it is fully seated. Remove the dipstick from
the tube and check the oil level. If the oil level is
low, remove the filler cap from the valve cover
and add enough of the specified oil to raise the
level to the Full mark on the dipstick
Important:
Be sure to keep the oil level
between the upper and lower mark on the
dipstick. If you overfill or underfill the engine
oil, you may damage engine when running it.
g002702
2. Oil-fill cap
(Figure 25).
6. Install the dipstick firmly in place.
Important:
You must fully seat the dipstick
in the tube to proper seal the engine
crankcase. Failure to seal the crankcase may
result in engine damage.
7. Pivot the seat down.
Changing the Engine Oil
and Filter
Service Interval: Every 100 hours (more often in
extremely dirty or dusty conditions).
Crankcase oil capacity: approximately 1.66 L (1-3/4
US qt) with the filter.
24
Figure 25
g351424