Table of Contents
Advertisement
BURNERS FEATURES
3
2
10
1
11
9
7
Burner with aluminium air inlet
Gas operation: From the supply line the gas fuel passes through the gas train (filter, safety valves, gas pressure regulator and butterfly
valve). The pressure regulator sets the gas pressure within the combustion head utilization limits. Air is supplied by a fan, which may be
onboard or separated depending on burner configuration, and is channeled through an air damper.
The air damper and the gas butterfly valve are actuated by servomotors according to load curves, in order to achieve the correct
proportion between fuel and air flows, and to optimize flue gas parameters.
The adjustable combustion head can improve the burner performance by controlling the flame geometry and combustion efficiency.
Fuel and air are routed through separated channels inside the combustion head, then mixed to ignite the flame inside the combustion
chamber. The ignition spark is provided by electrodes and a high voltage transformer (a pilot flame may also be employed, depending
on burner configuration).
Pre-ventilation of the combustion chamber is usually implemented according to gas directives.
The control panel, onboard or separated, allows the operator to monitor each operating phase.
PART I: SPECIFICATIONS
4
Note: the figure is indicative only
1
Control panel with startup switch
2
Gas valve group
3
Electrical panel
4
Cover
5
Blast tube + Combustion head
6
Flange
7
Actuator
8
Silcencer
9
Air pressure switch
10 Head adjusting ring nut
11 Fan motor
5
6
7
8
Burner with ABS polymer (silenced) air inlet
5
PART I: SPECIFICATIONS
Advertisement
Table of Contents
