Explanation Of Symbols On The Machine - Zenoah G2500 Owner's Manual

G2500/G2500 OPS

5. Explanation of Symbols on the Machine

WARNING
• For safe operation and maintenance, symbols are carved in relief on the machine.
According to these indications, please be careful not to make any mistake.
The port to refuel "MIX GASOLINE"
Position: Fuel cap
The port to top up chain oil
Position: Oil cap
Setting the switch to the "O" position, the engine stops immediately.
Position: Front at the top of the rear handle
Starting the engine. If you pull out the choke knob (at the back-right of the
rear handle) to the point of the arrow, you can set the starting mode as
follows:
• First-stage position – starting mode when the engine is warm.
• Second-stage position – starting mode when the engine is cold.
Position: Upper-right of the aircleaner cover
The screw under the "H" stamp is The High-speed adjustment screw.
The screw under the "L" stamp is The Slow-speed adjustment screw.
The screw at the left of the "T" stamp is the Idle adjustment screw.
Position: Left side of the rear handle
Shows the directions that the chain brake is released (white arrow) and
activated (black arrow).
Position:: Front of the chain cover
If you turn the rod by screwdriver follow the arrow to the "MAX" position,
the chain oil flow more, and if you turn to the "MIN" position, less.
Position: Bottom of the power unit
<G2500 OPS>
Shows the direction of the select lever for the OPS (one-push-start) and
"Super e-start".
Position: Upper side of the recoil starter
GB-8
01-G2500･G2500 ops_GB_306＿四.indd 8 13.7.4 5:43:55 PM