Explanation Of Symbols On The Machine - Zenoah G621AVS Owner's/Operator's Manual

8
(a)
(b)
(c)
(d)
(e)
(f)
English

4. Explanation of symbols on the machine

For safe operation and maintenance,
symbols are carved in relief on the
machine.
According to these indications, please
be careful not to make any mistake.
(a) The port to refuel "MIX GASOLINE"
Posiion: Fuel cap
(b) The port to top up chain oil
Position: Oil cap
(c) Setting the switch to the "|" position, the engine
starts.
Setting the switch to the "O" position, the engine
stops immediately.
Position: Rear-left of the unit
(d) Starting the engine. If you pull out the choke knob
(at the back-right of the rear handle) to the point of
the arrow, you can set the starting mode as follows:
• First-stage position – starting mode when the
engine is warm. (warm start)
• Second-stage position – starting mode when the
engine is cold. (cold start)
Position: Upper-right of the aircleaner cover
(e) The screw under the "H" stamp is The High-speed
adjustment screw.
The screw under the "L" stamp is The Slow-speed
adjustment screw.
The screw at the left of the "T" stamp is the Idle
adjustment screw.
Position: Left side of the rear handle
(f) Shows the directions that the chain brake is
released (white arrow) and activated (black arrow).
Position: Front of the chain cover