Table of Contents
Advertisement
Process
You can specify how to process your print jobs on your RISO printer, i.e. to
complete them without interruption or to interrupt them after a specified pro-
cess step. By interrupting your print jobs, you can check print position and
quality with test prints before printing process or change the print job flow
according to your print requirements. Click on the [M] bar and select a de-
sired process flow from the displayed list. The available process flows are as
follows :
Full Auto:
To complete print jobs without operator involvement on your RISO printer.
No pause is made between master-making and printing processes until the
end of print jobs.
Semi-Auto (Print):
To interrupt print jobs before each master-making process, thus allowing
you to handle a stack of printed copies, especially for duplex printing. You
can view the page image on the LCD of the printer to check what you are
about to print.
Semi-Auto (Master):
To interrupt print jobs before each printing process, thus allowing you to
check a sample print.
Manual:
To interrupt print jobs before each process step, i.e. both master-making and
printing processes.
IMPORTANT!
• For the Printer Driver, [Process] is available only when you select [Print
Only]. (See
Page
60) (The setting is not valid for [Storage Only].) For stored
data, set the [Process] mode from the printer display when the data is acti-
vated.
• For the USB flash-via-Printer Driver, master-making/printing is executed ac-
cording to the [Process] setting made here when [Destination]
set to [USB print (Auto process)]. For that reason, when [Semi-Auto (Print)]
or [Manual] is selected, master-making does not start automatically.
Setting the Print Conditions
(Page
Working with the Printer Driver
60) is
59
Advertisement
Table of Contents
